Denso BHT-200Q Bedienungsanleitung PDF herunterladen (Seite 105)

Chapter 2 Getting Started the BHT and System Menu

 Setting the RF options

Tapping the Option tab on the NIC Control menu displays the screen

shown at left.

You can set the following:

Power: Select the power mode for the wireless module.

For details about the parameters above, refer to Chapter 3, Section

3.1.2 "RF-Related Parameters."

 Setting the WEP keys

(Authentication: Open)

(40-bit WEP)

Tapping the WEP tab on the NIC Control menu displays any of the

following three types of screens according to the authentication type.

- At left: Open

- Below at left: Shared key (40-bit WEP)

- On the next page: Shared key (128-bit WEP)

You can set the following:

WEP: Set the authentication system when the WEP is enabled.

Open: Disable the encryption.

Shared (40-bit): Use a 40-bit WEP key.

Shared (128-bit): Use a 128-bit WEP key.

Key 1 through 4: Define four types of encryption keys--WEP keys

1 to 4. (available only when the Shared (40-bit)

or Shared (128-bit) is selected)

Transmit Key: Activate any one of the WEP keys 1 through 4

already defined. (available only when the Shared

(40-bit) or Shared (128-bit) is selected)

For details about each parameter, refer to Chapter 3, Section 3.1.2,

"RF-Related Parameters."

To enable the encryption with an WEP key, choose "Shared" in the

WEP box.

For Transmit Key, select an WEP key already defined.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 171 172

Keine Kommentare

Denso BHT-200Q Bedienungsanleitung Seite 105