Denso BHT-7000 Bedienungsanleitung PDF herunterladen (Seite 37)

Chapter 2. Getting Started the BHT-7000 and System Mode

WARNING

Only use the dedicated charger (CU-7000, C-700,

or C-750) for charging the lithium-ion battery

cartridge.

Using a different type of charger could cause

battery-rupture or leakage of battery fluid and

result in a fire, bodily injury, or serious damage

to property.

CAUTION

Never charge a wet or damp battery cartridge.

Doing so could cause the batteries to break, gen-

erate heat, rupture or burn.

• Before battery replacement, be sure to power the BHT-7000 off. Within three

minutes from the removal of the battery cartridge, load the battery cartridge to

avoid data loss. After battery replacement, power the BHT-7000 on and check

its operation.

• When replacing dry batteries, always replace both of them with new alkaline

manganese batteries (LR6).

• You may charge the lithium-ion battery cartridge with the optional CU-7000

communications unit or optional C-700/C-750 charger. For the charging pro-

cedure using the CU-7000, refer to Chapter 5. For that using the C-700/C-750,

refer to the "C-700 User's Manual"/"C-750 User's Manual."

• If the "Charge the battery!" or "Replace the batteries!" message appears after

the BHT-7000 undergoes any shock or impact, turn the power off and on and

then check the battery output level. The battery may not have run out.

NOTE

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 174 175

Keine Kommentare

Denso BHT-7000 Bedienungsanleitung Seite 37