Denso RC5 Spezifikationen PDF herunterladen (Seite 636)

100

101

21-84

Note (7): The shape of the window available to designate is a rectangle

with 0 degrees. If you designate any shape other than this, an

error occurs.

Note (8): The processing object is the screen designated with

VISWORKPLN.

Note (9): When this command is executed, the process screen 3

(VISWORKPLN 3) is used as a work area and data on the

process screen 3 are not guaranteed. Also, you cannot use

the process screen 3 for processing.

Note (10): You can obtain data with the processing result obtaining

function after executing an instruction.

Note (11): µ

µµ

µVision board (optional) is required for this command.

Note (12): If the searching mode size and the widow size coincide, the

correspondence degree only at that position is calculated.

Note (13): An angles measurement is executed when you set both [Start

Angle] and [End Angle] to 0.

Note (14): An angle measurement is executed as you set as [Start

Angle] = 0 and [End Angle] = 360, if you set both [Start Angle]

and [End Angle] to the same value other than 0.

VISSTATUS (n)

n Item

0 Execution Result

0 = Normal

-1 = Model Unregistered

-2 = Failure

-3 = Timeout

1 Number

2 Execution Time

VISGETNUM (a, b

b a = 0~49

0 Number

1 X Coordinate Value

2 Y Coordinate Value

3 Correspondence Degree

4 Angle [V1.4 or later]

5 X Coordinate Value for

Origin [V1.4 or later]

6 Y Coordinate Value for

Origin [V1.4 or later]

7 Angle from Angular Origin

[V1.4 or later]

8 unknown

9 unknown

1 2 ... 631 632 633 634 635 636 637 638 639 640 641 ... 691 692

Kommentare zu diesen Handbüchern

Keine Kommentare

Denso RC5 Spezifikationen Seite 636

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Robotik Denso RC5